Trench depth adjustment nching stop permits the saw blade to cut right through a workpiece. When the saw e Turning on and off 1. Pull in switc
Setting the fence square with the table 1. Make sure that the power cord is removed from the power source. 2. Push the saw arm down to its lowest p
CAUTION:To ensure correctblade rotation, always installthe blade with the bladeteeth and the arrow printedon the side of the bladepointing downwards.
10. Hold the operating handle (1) firmly and squeeze the switch trigger. Allow the blade to reach maximum speed and slowly lower the blade into and t
4. Retighten the miter lock (Fig. 15). WARNING: Be sure to tighten the miter lock before makinga cut. Failure to do so could result in the table y.
Maintenance WARNING: Always ensure that the tool is switched off and the plug is removed from the outlet before making any adjustments or maintenance
Exploded view and parts list 16
17
Item Stock # Description Item Stock # Description 1 70716-001 Screw 39 70716-039 Binding post 2 70716-002 Motor cover 40 70716-
Item Stock # Description Item Stock # Description 88 70716-088 Rolled pin 133 70716-133 Spring 89 70716-089 Pivot shaft 134 707
TABLE OF CONTENTS Specifications ……………………………………………………………………………………… 3 General safety rules………………………………………………………………………………... 4 Additional safety rul
Limited two years warranty WEN® Products is committed to build tools that are dependable for years. Our warranties are consistent with this commitmen
Specifications Model Number 70716 Input Power 120V, 60Hz, 15A No Load Speed 5500 RPM Blade Size 10" x 5/8" bore Number
General safety rules WARNING:Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock,
4. Power tool use and care a. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job b
Additional safety rules for miter saws • Ensure that the lighting is adequate. • Do not use the saw unless the guards are in place. • Do not use th
Know your product Before using the saw, familiarize yourself with all the operating features and safety requirements. 115141312111623451
Operation and adjustments Unpacking Due to modern mass production techniques, it is unlikely that your WEN® tool is faulty or that a part is missing.
Bevel lock The bevel lock (11) is used to set the blade at the desired bevel angle (Fig. 5). The miter saw bevels from 0° to 45° left. WARNING: Be s
Kommentare zu diesen Handbüchern